How do you fix the 5D code on a Whirlpool washer?

Alton Alexander
By Alton AlexanderUpdated on June 4th, 2022

The whirlpool washer 5d code is an error code that indicates that the washer is not draining properly. This can happen for a variety of reasons, but the most common cause is that the drain pump is not working properly. Other causes can include a clogged drain hose or a problem with the drain pump itself. If the washer is not draining properly, it will eventually stop working altogether.

You are here because you have a question about:

  • whirlpool sd error code fix
  • whirlpool duet sport washer error code 5d
  • 5d error code on whirlpool washer
  • whirlpool washer 5d code

Still not working? maybe try one of these options:

  1. The 5D error code on a Whirlpool washer indicates a problem with the water level sensor. Try these steps to fix the issue:
  2. -Check the water inlet hoses to make sure they are not kinked or clogged.
  3. -Clean the inlet screens.
  4. -Make sure the washer is level.
  5. -Check the drain hose for proper installation.
  6. -Unplug the washer and remove the rear panel.
  7. -Locate the water level sensor and clean it with a cotton swab.
  8. -Reconnect the wiring harness and replace the rear panel.
  9. -Plug in the washer and run a cycle to see if the code has cleared.