How do you fix the Whirlpool dryer F1 code?

Alton Alexander
By Alton AlexanderUpdated on June 4th, 2022

The Whirlpool dryer F1 code indicates that there is a problem with the dryer's control board. This error code can be caused by a variety of things, including a power surge, a faulty control board, or a problem with the dryer's wiring. If you see the Whirlpool dryer F1 code, you should unplug the dryer and check the control board for any damage. If the control board is damaged, you will need to replace it. If the control board is not damaged, you should check the dryer's wiring for any loose or damaged wires.

People like you are also looking for:

  • error code f01 whirlpool duet dryer
  • whirlpool duet sport dryer error code f01
  • f01 error code whirlpool dryer
  • whirlpool dryer error code f01
  • whirlpool dryer f1 code

1. Check the dryer's lint screen and clean it if necessary

  1. Look for debris or lint on the lint screen. If there is debris or lint on the lint screen, you will need to clean it.
  2. Use a vacuum cleaner to clean the lint screen.
  3. If there is still debris or lint on the lint screen, you will need to replace the lint screen.

2. Make sure the dryer is properly ventilated

  1. Look for any obstructions in the exhaust system.
  2. Check to see if the vent is open.
  3. Make sure the lint filter is clean and in place.
  4. If the vent is open, close it using a clamp or a piece of wire.
  5. Check the dryer's ductwork for any cracks or damage.
  6. Replace any damaged or cracked ductwork.
  7. Check the dryer's fan for any obstructions.
  8. If the fan is obstructing the flow of air, remove the fan.
  9. Open the dryer's door and check the inside for any lint or debris.
  10. Close the dryer's door and start the dryer.
  11. If the dryer starts and the f1 code returns, the dryer is not properly ventilated and must be replaced.

3. Inspect the dryer's heating element and replace it if necessary

  1. Remove the front panel.
  2. Inspect the heating element for signs of damage, such as scorching, blackening, or melted parts. If the heating element is damaged, replace it.
  3. Reinstall the front panel.

4. Check the dryer's thermostat and replace it if necessary

  1. Check the thermostat to make sure it is set to the appropriate temperature. If it is not, set the thermostat to the proper temperature and close the dryer door.
  2. If the whirlpool dryer f1 code is still occurring, replace the thermostat.

If the answers above didn't work then you should also try:

  1. Reset the dryer's circuit breaker.
  2. Contact a professional for further assistance.