The elsafe ser error code is a safety error code that is caused by a problem with the electrical system. This error code can be caused by a variety of things, but the most common cause is a problem with the wiring. This error code can also be caused by a problem with the circuit breaker or a problem with the fuse box.
1. Restart the computer
- Turn off the computer and disconnect any external devices.
- Remove the battery if the computer has one.
- Reset the computer by pressing the power button for at least 20 seconds and then releasing it.
- Disconnect the power cord.
- Reconnect the power cord and turn on the computer.
- If the computer starts up normally, try to fix the problem using the instructions below.
- If the computer still doesn't work, you may need to replace the computer.
2. Turn off the computer and unplug the power cord
- Shut down the computer by pressing and holding down the "shut down" button on the keyboard.
- Unplug the power cord from the wall outlet.
- Wait 10 seconds, and plug the power cord back in.
- Turn on the computer and wait until the startup process completes.
- If the computer does not start, try to reset the computer by pressing the "reset" button on the keyboard.
3. Update the BIOS
- Check the system is powered on and connected to an AC outlet
- Enter the BIOS on the PC
- Navigate to the System Configuration menu
- Select the Advanced tab
- Select the Update BIOS button
- Save the updated BIOS file to a USB drive
- Restart the PC
- Once the PC has restarted, insert the USB drive containing the updated BIOS file
- Select the BIOS Update option from the BIOS menu
- Follow the on-screen instructions
4. Run a virus scan
- Boot your computer into Safe Mode with Networking.
- Click on Start, type "cmd" and press Enter.
- Type "scannow" and press Enter.
- If the scan results show any viruses, click on Fix All and then reboot your computer.
- If the scan results do not show any viruses, click on OK.
- If you are prompted to restart your computer, do so.
- After your computer has restarted, re-open elsafe.
- Click on File, then on New.
- Type elsafe.ini and press Enter.
- Click on OK.
- Double-click elsafe.ini to open it.
- Under [Server], type the IP address of your elsafe server.
- Under [Settings], type the port number of your elsafe server.
- Under [General], type the path to your elsafe.ini file.
- Under [Log], type the path to the elsafe.ini file's log file.
- Click on Save.
- Click on Close.
5. Check for loose cables
- First, identify the cables that seem to be loose.
- Next, use an Allen wrench to tighten the cables that seem to be loose.
- Finally, check to see if the elsafe ser error code has been resolved.
6. Replace the CMOS battery
- Turn off the computer and unplug the power cord.
- Remove the screws that secure the bottom cover.
- Remove the bottom cover.
- Remove the battery.
- Replace the battery.
- Replace the bottom cover.
- Replace the screws that secure the bottom cover.
- Reconnect the power cord.
Still not working? maybe try one of these options:
- Reset the BIOS settings.
- Replace the motherboard.