The maytag f20 error code is a error code that indicates that the washer is not draining properly. This error code can happen for a few different reasons. One reason this error code can happen is if the washer is not level. If the washer is not level, it will not be able to drain properly. Another reason this error code can happen is if the drain hose is kinked. If the drain hose is kinked, it will not be able to drain properly. Finally, this error code can happen if the drain pump is not working properly. If the drain pump is not working properly, it will not be able to drain properly.
Other common searches for this error include:
- maytag epic z washer error code f20
- maytag f20 error
- First, check to ensure that the washer is properly plugged into an outlet and that the outlet is receiving power
- Next, check the water supply valves to make sure they are fully open
- If the water supply valves are open and the washer is still not filling properly, then the inlet water fill hoses may be clogged
1. First, check to ensure that the washer is properly plugged into an outlet and that the outlet is receiving power
- Check the washer power cord to ensure that it is securely plugged into an outlet and that the outlet is receiving power.
- Check the washer's plug to ensure that it is properly inserted into the outlet.
- Check the washer's fuse box to ensure that there is no power issue.
- Check the washer's breaker if there is an issue with the outlet.
- If all of the above steps fail to fix maytag f20 error 6, then the washer may need to be serviced.
2. Next, check the water supply valves to make sure they are fully open
-First turn off the power to the refrigerator by flipping the breaker switch to the off position. -Next, remove the four screws that hold the top panel of the refrigerator in place. -Next, remove the top panel of the refrigerator. -Next, locate the water supply valves and make sure they are fully open. -Finally, replace the top panel of the refrigerator and re-install the screws.
3. If the water supply valves are open and the washer is still not filling properly, then the inlet water fill hoses may be clogged
If the water supply valves are open and the washer is still not filling properly, then the inlet water fill hoses may be clogged. To fix this, follow these steps:
- Open the inlet water fill hoses by removing the cap on the end and then pulling them off of the water supply valve.
- If the hoses are clogged, use a pipe cleaner to clean the inside of the hoses.
- Replace the hoses if they are clogged.
Some users might also have success with the following opitons:
- If the washer is still not filling properly after checking the water supply valves and inlet water fill hoses, then the water pressure may be too low. Check the water pressure at the household water supply and make sure it is above 60 psi. If the water pressure is below 60 psi, contact the local water utility company to have the pressure increased.
- Finally, if the washer is still not filling properly,