How to fix the collar 43 good wolf error code?

Collar 43 is a good wolf error code that happens when the animal being tracked moves out of the range of the GPS collar. This is usually due to the animal moving into an area with no cell phone coverage or into a heavily forested area.

You are here because you have a question about:

• cold war error code collar 43 good wolf
• collar 43 good wolf error code xbox
• error code collar 43 good wolf
• collar 43 good wolf error code

• Check the electrical connection to the collar
• Check the batteries and make sure they are properly installed
• Check the GPS signal and make sure it is strong

1. Check the electrical connection to the collar

1. Make sure that the power to the collar is turned off and then unplug the collar
2. Check all of the electrical connections on the collar
3. Reconnect the power to the collar and test to see if the error code has been fixed

2. Check the batteries and make sure they are properly installed

1. Open the battery cover on the collar.
2. Look for the two batteries. Make sure they are properly installed in the battery holder.
3. Close the battery cover.
4. Press the power button to turn on the collar.
5. If the collar displays an error code, follow the instructions in the error code.

3. Check the GPS signal and make sure it is strong

1. Pull over to the side of the road and turn off your engine.
2. Open the driver’s side door and step out.
3. Look up and down the road to make sure there is no traffic.
4. Hold your hand up in the air and wait a few seconds until you see a green light from the GPS antenna.
5. Walk to the center of the road and place the GPS collar on your neck.
6. Double-check that the collar is properly placed on your neck by looking at the LED light on the collar.
7. Reattach the magnetic clip to the back of your collar.
8. Close the driver’s side door and wait for the green light on the GPS antenna to turn off.
9. Start your engine and drive back to your original location.
10. Repeat the steps above to check the GPS signal in the opposite direction.

Some users might also have success with the following opitons:

1. Check the software version and make sure it is up to date.
2. Check the transmitter and make sure it is properly installed.
3. Check the antenna and make sure it is properly installed.
4. Check the receiver and make sure it is properly installed.
5. Call customer support for assistance.