How do you fix a Whirlpool Duet Washer F11 error code?

The whirlpool duet washer error code F11 means that there is a problem with the washer's drain pump. This error code can be caused by a clogged drain pump, a faulty drain pump, or a loose wire connection to the drain pump. If the drain pump is clogged, it will need to be cleaned out. If the drain pump is faulty, it will need to be replaced. If the wire connection to the drain pump is loose, it will need to be tightened.

Other common searches for this error include:

• whirlpool washer error code f11
• whirlpool duet washer f11 error code

• Check for any clothing or other items that may be blocking the washer's door from closing properly
• Inspect the washer's door seal and make sure it is clean and free of any debris
• Verify that the washer isleveled correctly
• Make sure that the washer's water supply valves are turned on fully

1. Check for any clothing or other items that may be blocking the washer's door from closing properly

To check for clothing or other items that may be blocking the washer's door from closing properly, follow these steps:

1. Remove any clothing or other items that may be blocking the door from closing properly.
2. Check to see if the door will close properly with the clothes or other items removed.
3. If the door still does not close properly, remove any additional items from the door and check the alignment of the door's hinge pins.
4. If the door still does not close properly, replace the washer's door assembly.

2. Inspect the washer's door seal and make sure it is clean and free of any debris

1. Open the front door of the washer.
2. Look for any debris or water spots on the door seal.
3. If there are any water spots or debris on the seal, use a cloth or paper towel to clean it off.
4. Make sure the seal is free of any debris.
5. Close the door and test the washer to see if the error code has been fixed.

3. Verify that the washer isleveled correctly

1. Open the door of the washer and check to see if the water level is correct. If the water level is too high, the washer may not spin properly and may give an error code.
2. If the water level is correct, check to see if the Drum is level. If the Drum is not level, the washer may not spin properly and may give an error code.
3. If the Drum is level, check to see if the agitator is level. If the agitator is not level, the washer may not spin properly and may give an error code.
4. If the agitator is level, check to see if the belt is tight. If the belt is not tight, the washer may not spin properly and may give an error code.

4. Make sure that the washer's water supply valves are turned on fully

1. Open the front cover of the washer.
2. Inspect the water supply valves.
3. If the water supply valves are not turned on fully, turn them on fully.
4. Close the front cover of the washer.
5. Test the washer.

Some users might also have success with the following opitons:

1. Check the washer's inlet hoses to make sure they are not kinked or clogged.
2. Run a diagnostic test on the washer to determine the exact cause of the error code.